Earrings made with Wire Wrapping Tools

1.   Insert the metal pins into the aluminium board in a desired pattern.

2.   Wrap a piece of metal wire around the pins.

3.   Finish by making a loop.

4.   Cut off the excess wire.

5.   Put beads onto a head pin and bend it to one side.

6.   Make a loop.

7.   Cut off the excess pin.

8.   Attach the pendant to the metal shape made with the wire wrapping tool set.

9.   Cut a feather in half. Remove some of the soft feathers where the cut was made to create a small piece of bare “stalk”.

10.   Glue the small stalk into an end cap.

11.   Squeeze the end cap.

12.   Attach the pendant feather to the metal shape made with the wire wrapping tool set.

13.   Put beads onto an eye pin and bend it.

14.   Twist to form a loop.

15.   Cut off the excess pin.

16.   Hand the pendant onto the metal shape made with the wire wrapping tools and close the loop.

17.   Open the loop at the other end.

18.   Attach a French earwire and close the loop again.