Un bracelet tressé avec des perles rocailles
#v14587
Chacun de ces bracelets est réalisé avec des petites perles de verre enfilées sur un fil pour bijoux lequel est ensuite tressé entre deux bouts de ficelle de coton ciré. Un bracelet se ferme à l'aide d'une fixation tressée et l'autre avec des noeuds réglables coulissants.
Comment faire Téléchargez nos instructions étape par étape
1 Cut a 70 cm piece of 1 mm cotton cord. Double over the cotton cord and attach the loop end with a suitable space (measure according to the beads) onto a clip board. Cut a 150 cm piece of jewellery wire and thread 5 rocaille seed beads onto the middle. Place the jewellery wire with the beads underneath the two horizontal cords and then up and over them from each side and through the row of beads.
2 Continue by threading another 5 new rocaille seed beads onto the jewellery wire - first from one side and then from the other side, so the wires cross. At the sides, the wires are placed underneath the cord. (The pattern is made by varying the colour and the order of the beads).
3 Finish when the desired length is reached. Tie a double knot with the jewellery wire at each side.
4 Remove the bracelet from the clip board and tie a knot at each end with the cotton cord close to the woven sections. Make a braided fastening by crossing the cords as shown and then braid with a new piece of cord. Alternatively you may make sliding adjustable knots. See the jewellery school on our website for further instructions (ideas No. 12544 and 12499).
Another example Using rows consisting of 5 rocaille seed beads results in a 8 mm wide bracelet.
Allez aussi explorer dans
