Une assiette en argile autodurcissante décorée selon la technique des bulles de savon

1 Etalez l'argile à l'aide de deux bâtons en bois ronds de 8 mm de diamètre pour obtenir un assiette d'épaisseur homogène (soit 8 mm). L'assiette doit avec une épaisseur de 7 mm min.

2 Place the attached template on top of the clay and cut out.

3 Remove the excess clay.

4 Dip the modelling tool in water and smooth out the edge.

5 Make a hole for hanging and leave to dry. Turn the plate over a couple of times whilst drying. Drying time is approx. 48 hours depending on the room temperature. You may place it near a radiator for drying. A tip: If small cracks appear in the clay once dry, you can repair these by mixing a small amount of clay with a bit of water to form a creamy consistency. Fill the cracks with the mixture, preferably with a brush. Leave to dry. Any uneven areas on the plate can be sanded smooth with a sanding sponge or with fine sandpaper.

6 Bubble technique: Mix 1 part washing up liquid with 2 parts water and a couple of drops of Plus Color craft paint.

7 Mix well.

8 Blow into the mixture with a straw. The mixture needs to bubble a lot. Practice the technique and check if the mixture bubbles sufficiently. Too much paint in the mixture may reduce the amount of bubbles. Make a couple of bubble tests with the straw, for example onto a piece of card, before blowing the mixture onto the plate. You may blow more bubbles onto the plate when the first layer is dry.

9 Raise the plate, for example on a glass. Blow lots and lots of bubbles onto the plate. Avoid tipping the glass when blowing bubbles. It is important that only bubbles fall onto the plate.

10 Let the bubbles burst by themselves.

11 Leave to dry and the plate is finished.

12 Here is the mixture made with black Plus Color craft paint.

13 Here we have used two colours for the bubbles. First blow with Dusty Rose Plus Color craft paint. Leave to dry and then blow bubbles with black Plus Color craft paint.

Template -