D'idées créatives
Mermaid and Sea Creatures Jewellery and a Keyring Fob from Shrink Plastic
#v15169
Make colourful jewellery and keyring fobs from shrink plastic with pre-printed mermaid, seahorse, starfish and mussel designs. They are ready for colouring in immediately to use for home-made jewellery and keyring fobs.
#v15169
Comment faire
1 
Colour in the shrink plastic designs using colouring pencils.
Colour in the shrink plastic designs using colouring pencils.2 
Cut out the figures.
Cut out the figures.3 
Remember to make a hole at the top using revolving punch pliers before putting the figure in the oven.
Remember to make a hole at the top using revolving punch pliers before putting the figure in the oven.4 
Place the figure on a baking sheet covered with baking paper in a household oven at 170°C. After a few minutes the figure will start to shrink and curl up and then it straightens out again and can be taken out of the oven.
Place the figure on a baking sheet covered with baking paper in a household oven at 170°C. After a few minutes the figure will start to shrink and curl up and then it straightens out again and can be taken out of the oven.5 
Attach a round jump ring through the hole.
Attach a round jump ring through the hole.6 
Cut a piece of bead chain and feed it through the round jump ring.
Cut a piece of bead chain and feed it through the round jump ring.Another variant 
Make keyring fobs using the same procedure.
Make keyring fobs using the same procedure.Allez aussi explorer dans
