D'idées créatives
Un prote-clés licorne en plastique thermorétractable
#v14857
Ces dessins pré-imprimés sur du plastique thermorétractable sont colorés aux crayons de couleurs. Les figurines sont découpées et un trou est fait sur le haut. Elles sont ensuite rétrécies dans un four ménager à 170°C puis accrochées à une boucle placée sur un porte-clés.
#v14857
Comment faire
1 
Colour in the pre-printed design on the shrink plastic sheet using colouring pencils.
Colour in the pre-printed design on the shrink plastic sheet using colouring pencils.2 
Cut out the figure with a pair of scissors and make a hole at the top using punch pliers. It can then be attached as a key fob on a keyring. Remember that the hole shrinks as well.
Cut out the figure with a pair of scissors and make a hole at the top using punch pliers. It can then be attached as a key fob on a keyring. Remember that the hole shrinks as well.3 
Place the figure on a baking sheet covered with baking paper. Put in a household oven at 170°C. After a few minutes the figure will start to shrink and curl up and then it straightens out again and can be taken out of the oven.
Place the figure on a baking sheet covered with baking paper. Put in a household oven at 170°C. After a few minutes the figure will start to shrink and curl up and then it straightens out again and can be taken out of the oven.4 
Attach the figure to the keyring using a round jump ring. Now squeeze the round jump ring with flat nose pliers to close it.
Attach the figure to the keyring using a round jump ring. Now squeeze the round jump ring with flat nose pliers to close it.Another example 
-
-Allez aussi explorer dans
