Creatieve ideeën
LED lichtslinger gedecoreerd met bladerkapjes
#v15603
De lichtjes van deze LED lichtslinger zijn gedecoreerd met gedroogde bladeren. De bladeren zijn aan de onderkant vastgezet met design tape in dezelfde kleur.
#v15603
Hoe werkt het
1 
Use four skeleton leaves, a small 2.5 cm piece of design tape and a small piece of power tape for each bulb.
Use four skeleton leaves, a small 2.5 cm piece of design tape and a small piece of power tape for each bulb.2 
Carefully assemble the leaves around the wire just underneath the bulb.
Carefully assemble the leaves around the wire just underneath the bulb.3 
Attach the design tape tightly, but carefully, once all four leaves are assembled.
Attach the design tape tightly, but carefully, once all four leaves are assembled.4 
Cut a small piece of power tape and attach this onto the end of the design tape. This is to make sure that the tape is attached properly. Remove the red foil from the power tape and tighten the end of the design tape around the wire.
Cut a small piece of power tape and attach this onto the end of the design tape. This is to make sure that the tape is attached properly. Remove the red foil from the power tape and tighten the end of the design tape around the wire.Another variant 
You may decorate the LED lights in different colours. In this photo each bulb is decorated with two gold skeleton leaves and matching design tape.
You may decorate the LED lights in different colours. In this photo each bulb is decorated with two gold skeleton leaves and matching design tape.Kijk ook bij
